LPKF ProtoMat S64 - Processing the Material

ProtoMat S64/S104
Operating the system
V. 1.0 | LPKF Laser & Electronics AG
95/160
6.3.3 Processing the material
This chapter describes how the material is processed based on the prepared data.
This is done by executing the following steps:
 Placing and fastening the material on the processing table
 Starting processing
 Defining the material settings
 Placing the layout
 Processing the material
 Turning the material over (phase FlipMaterial)
 Searching fiducials
 Processing the material (Top side)
WARNING
Health hazard by gases or dusts!
Processing materials can produce gases or dusts hazardous to health.
 Process only materials that are approved by LPKF.
 Only work with an extraction system that is switched on and is working properly.
CAUTION
Burn hazard by hot surfaces!
During processing, some system components can heat up so much that direct
contact can cause burns.
 Always wear your personal protective equipment.
CAUTION
Risk of injury by sharp edges and points!
Improper handling of the tools used can cause cuts and puncture wounds.
 Always use the delivered insertion tool.
 Always store the tools in the tool box.
 Never touch the processing head during operation.
CAUTION
Risk of injury by sharp edges!
When handling the base materials, sharp edges can cause cuts and puncture
wounds.
 Always wear protective gloves.