Placing and fastening the material on the processing table
Before any processing procedure, a sinter plate and the base material have to be
placed and fastened on the processing table.
1. Ensure that the processing table is clean.
2. Place the supplied sinter plate (1) onto the processing table.
Risk of injury by sharp edges!
When handling the base material, sharp edges of the material an cause cuts and
puncture wounds.
Always wear protective gloves.
3. Place the base material (2) onto the sinter plate (1):
4. Fasten the material to be processed along its edges onto the processing table
using the adhesive tape included in the delivery.
The adhesive tape must be fully removable. Use the provided adhesive tape or an
equivalent adhesive tape.
To Next Page
Loading...
