V. 1.0 | LPKF Laser & Electronics AG
6.3.4 Switching off the system
This chapter describes how to switch off the system after use. If necessary, clean the
system in accordance with the intervals (see maintenance schedules).
Switching off the system
Ensure that a tool is in the collet or a tool is in the tool magazine before switching off
the system.
1. Close CircuitPro PM.
The processing head moves to a safe position. If no tool is in the collet, a tool is
picked up from the tool magazine.
2. Use the On/Off switch to switch off the system.
3. Switch off the extraction system by pressing the Power button.
The system has been switched off.
To Next Page
Loading...
