UM-1151140EN, Rev. C, May 2016
Chapter 4
System Installation and Initial Setup
4.1. Introduction
The Smart532 laser system has passed full quality assurance testing before
shipment and should be operational upon delivery.
Your local Lumenis representative initially uncrates, inspects, sets up and
installs the laser to ensure that it is working properly. In addition, Lumenis
provides in-service training to ensure that your surgical staff is
experienced with the performance and safety considerations of the laser.
Thereafter you, or the nursing staff at your facility, will perform the daily
maintenance routines associated with the laser and delivery devices,
including inspecting and cleaning the laser and delivery devices,
connecting and disconnecting the delivery devices, and verifying the
aiming beam. These procedures are detailed in this manual and in the
delivery device operator manuals.
In Canada this instrument must be installed and operated according
to CAN/CSA-Z386-08: Laser Safety in Health Care Facilities.
4.2. Unpacking the
System
The Smart532 system is shipped in a shockproof container. Contents may
vary according to the purchase agreement with Lumenis, but the parts and
accessories generally shipped in the container are:
● Smart532 system console
● Safety eyewear
● Footswitch
● Door interlock connector plug
● Laser danger sign(s)
● Power cable
● Operator’s manual CD
To unpack the Smart532 system, carefully remove all components from
the shipping container. Save all packaging materials in case repacking and
shipping becomes necessary at a later date.
Any damage to the packaging or to the system found prior to
opening the packaging, or during unpacking and installation of the
system, should be immediately reported to your Lumenis
representative and to the insurance carrier.
To Next Page
Loading...
