UM-1151140EN, Rev. C, May 2016
System
Installation
and
Initial
Setup
4.6. Transporting and
Storage
Prepare the system for transport as follows:
1.
Set the system to Standby mode and power it down by unplugging it
from the wall outlet.
2.
Disconnect the delivery system(s) from the laser system. If the
delivery device is single-use dispose of it properly. Otherwise, inspect
and clean the delivery system(s) as instructed in the appropriate
operator’s manual(s).
3.
Disconnect the footswitch from the laser.
4.
Disconnect the remote interlock or the remote interlock emulator.
5.
Clean the exterior surfaces of the laser as instructed in the
Maintenance chapter of this manual.
Caution
Do not ship the system without the factory packaging materials.
Doing so may result in damage to the components during shipping
and void the warranty. Contact Lumenis if packaging materials or
repacking instructions are required.
To Next Page
Loading...
