LUMENIS smart532 - 4.5.4. Connect a Delivery System

UM-1151140EN, Rev. C, May 2016
4-9
Smart532
™
System Installation and Initial Setup
Warning
4.5.4. Connect a
Delivery System
● To avoid possible damage to the laser, use only qualified,
compatible Lumenis delivery systems. Using after-market
devices may jeopardize safe operation or damage the laser
and will void your Lumenis warranty or service contract.
● When using a fiber-optic delivery system always inspect the
fiber-optic cable to ensure that it has not been kinked,
punctured, fractured or otherwise damaged. The fiber-optic
cable may be damaged if stepped on, pulled, left lying in a
vulnerable position, kinked or tightly coiled. Do not clamp the
cable with a hemostat or other instruments. If sterile tape is
used, always remove the tape before lifting the cable. A
damaged fiber-optic cable may cause accidental laser
exposure or injury to the treatment room personnel or patient,
and/or fire in the treatment room.
● Carefully inspect any delivery system’s sterile packaging to
ensure that it has not been torn or punctured. If there is any
damage to the sterile packaging, do not use the delivery
system.
A variety of delivery systems
1
are compatible with the Smart532 laser
system. To connect a delivery system, attach the device’s laser connector
to an available fiber connection port on the system’s front or rear panel
(see Figure 4-2 or Figure 4-3). Attach any additional connectors to the
appropriate accessory connection port. Refer to the appropriate delivery
system’s operator manual for detailed connection and operating
instructions.
When a delivery system is properly connected, the name of the device will
be displayed on the control panel (see Chapter 5).
If the delivery system is not properly connected, an error message will be
displayed on the control panel. Verify that the delivery system is properly
connected to the appropriate connection ports before turning the laser
system on. If the delivery system is not compatible with the Smart532
laser system, an error message will be displayed on the control panel.
1
Optional purchase equipment