SAFETY INSTRUCTIONS
Only use the Power Source supplied by Magicard with the Printer.
Do not to spill any liquid on the Printer.
If using this printer in Germany:
To provide adequate short-circuit protection and over-current protection for this Printer, the building installation must be
protected by a 16 Amp Circuit Breaker.
Bei Anschluß des Druckers an die Stromversorgung muß sichergestellt werden, daß die Gebäudeinstallation mit einem
16 A-Überstromschalter abgesichert ist.
When Handling the Printer:
Avoid touching the thermal printing edge of the Print Head. Any grease and contamination will shorten its life.
Before transporting the Printer, remove the dye film and Card Hoppers and pack the Printer in its original packaging.
Location Requirements for your Printer:
A clean, dry level surface.
Cable access at the rear.
Allowance for air circulation.
An adequately ventilated room.
The correct Power Supply Unit provided by Magicard.
Ambient temperature +10 to +30 degrees Centigrade.
Relative Humidity 20/70% RH.
Protection from direct sunlight and chemicals.
Protection from abrupt temperature changes.
To Next Page
Loading...
