Magicard Rio Pro - Page 77

Ultra Electronics Card Systems
Rio Pro Maintenance Manual
- 77 -
SECTION 13 ERROR CODE LIST CONT
Error Number
Displayed Error
Error Code
Description of Problem
24
General Error. Please contact Magicard
Technical Support quoting Error code.
24:08
Error is shown while trying to hand feed a Card into the
printing area. If the Printer sees the rear Card Sensor
block before the front and middle Card Sensors the error
is displayed. This could possibly indicate that both the
front and middle Card Sensors have dropped out of
position, or that the rear Sensor is faulty.
24:09
Error is shown while trying to hand feed a Card into the
printing area. If the Printer sees the middle Card Sensor
block before the front one clears the error is displayed.
This could possibly indicate that the front or middle Card
Sensor is faulty.
24:10
Error is shown while trying to hand feed a Card into the
printing area. If the Printer sees the rear Card Sensor
block before the front or middle Card Sensor the error is
displayed. This could possibly indicate that the front Card
Sensor has failed, that the middle Card Sensor has
dropped out of position or that the rear Sensor is faulty.
24:11
Error is shown while trying to hand feed a Card into the
printing area. If the Printer sees the rear Card Sensor
block before the middle Card Sensor the error is
displayed. This could possibly indicate that the middle
Card Sensor has dropped out of position, or that the rear
Card Sensor is faulty.
24:12
Error is shown while attempting to write a downloaded
Firmware file into Flash memory. If the encrypted
checksum of the file is invalid the error is displayed. This
would mean that the Firmware file has been either
corrupted during transmission, or modified by a third
party.
24:13
Error is shown while attempting to move the Card into the
standby position. If the Firmware data relating to the
current position of the Card is invalid the error is
displayed. This should never happen.
24:18
24:19
24:20