Magnetek 2001-G+M - Page 168

IMPULSE•G+ Mini Advanced Instruction Manual – March 2014
A-4
B01.18 Reference Priority
00: Digital Reference Only
01: Analog Reference Only
02: Higher Reference Select
00* 00–02 -- 5-3
B02.01 Frequency Reference Upper Limit 100.0 0.0–110.0 % 5-5
B02.02 Frequency Reference Lower Limit 0.0 0.0–110.0 % 5-5
B02.03 Reference 1 Lower Limit 2.0* 0.0–110.0 % 5-5
B02.04 Alt Upper Limit 100.0 0.0–110.0 % 5-5
B03.01 Reference Source
00: Digital Operator
01: Terminal
02: Communication
04: Pulse Input
01 00–02, 04 -- 5-6
B03.02 Run Source
00: Digital Operator
01: Terminal Block
02: Communication
03: Not Used
04: Not Used
01 00–04 -- 5-6
B03.03 Stop Method
00: Decel to Stop
01: Coast to Stop
02: DC Injection Braking
04: Decel with Timer
01* 00–02, 04 -- 5-6
B03.04 Change Motor Rotation
00: Normal Rotation
01: Exchange Phases
00 00–01 -- 5-12
B03.07 Local/Remote
00: Cycle External Run
01: Accept External Run
00 00–01 -- 5-13
B03.10 Allow Run at Power UP
00: Disabled
01: Enabled
00 00–01 -- 5-13
B03.15 Reference Selection
00: Operator
01: Terminal Block
02: Communication
03: Not Used
04: Pulse Input
01 00–04 -- 5-13
B03.16 Reference Source
00: Operator
01: Terminal Block
02: Communication
03: Not Used
01 00–03 -- 5-13
B05.01 Accel Time 1 5.0* 0.0–25.5 sec 5-14
B05.02 Decel Time 1 3.0* 0.0–25.5 sec 5-14
B05.03 Accel Time 2 2.0 0.0–6000.0 sec 5-14
B05.04 Decel Time 2 2.0 0.0–6000.0 sec 5-14
B05.05 Accel Time N Change 2.0 0.0–25.5 sec 5-14
B05.06 Decel Time N Change 2.0 0.0–25.5 sec 5-14
B05.08 Fast Stop Time 1.0 0.0–25.5 sec 5-14
Parameter Parameter Name Default Range Units
Reference
Page
* Parameters defaults changed by X-Press Programming
** Parameters changed by E01.03
*** Value depends on drive model
**** Default value depends on control method