Manitowoc Grove RT9150E - GENERAL MAINTENANCE OVERVIEW; DAILY OR 10 HOUR CHECK LIST

6-1
RT9150E OPERATOR MANUAL MAINTENANCE CHECKLIST
Published 2-23-2017, Control # 644-00
Grove
6
SECTION 6
MAINTENANCE CHECKLIST
SECTION CONTENTS
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-1
Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-1
Daily or 10 Hour Check List. . . . . . . . . . . . . . . . . . 6-1
Weekly or 50 Hour Check List . . . . . . . . . . . . . . . . 6-2
GENERAL
This section contains a list of daily inspection and
maintenance checks. Performing the checks will help
maintain the safety, dependability, and productivity designed
into your crane.
Record results in the Inspection and Lubrication Service Log.
INSTRUCTIONS
Refer to your Service Manual for specific maintenance and
adjustment procedures.
Refer to Section 5, Lubrication (in this Operator’s Manual) for
lubrication intervals, types of fluids and lube point locations.
Daily or 10 Hour Check List
1 Air Cleaner: Check for proper service/level.Check for cracks or leaks.
2 Anti-Two-Block (A2B): Check for proper operation while operating machine. Check connectors and wiring for
proper alignment and insulation.
3 Back-up Alarm: Check for proper operation while operating machine.
4 Boom and Attachments: Is item properly installed on machine. Check for excess dirt, grease, or foreign matter.
Check for proper operation while operating machine.
5 Boom Angle Indicator: Check for proper operation while operating machine.
6 Brakes (Swing, Foot & Parking): Check for proper working order. Check for proper operation while operating
machine.
7 Brakes and Air System (if equipped): Check for proper working order. Check for proper operation while
operating machine. Drain moisture.
8 Cooling System: Check for proper service/level. Check for cracks or leaks.
9 Crankcase: Check for proper service/level. Check for excess dirt, grease, or foreign matter.
10 Fuel Tank: Check for proper Level and fill if needed
11 Fuel/Water Separator: Drain moisture.
12 Gauges and Instruments: Check for proper working order. Check for proper reading while operating engine.
Check for proper operation while operating machine.
13 Hoists: Is item properly installed on machine. Check for excess dirt, grease, or foreign matter.Check for proper
operation while operating machine.
14 Hook Block & Headache Ball Safety Latch: Check for proper working order. Check for cracks and leaks. Check
for excessive wear.
15 Hourmeter: Check for proper working order. Check for proper reading while operating engine.
16 Hydraulic Oil Filter: Check for proper service/level.
17 Hydraulic Tank: Check for proper service/level. Check for excess dirt, grease, or foreign matter.
18 Rated Capacity Limiter: Check for proper operation while operating machine. Check connectors and wiring for
proper alignment and insulation.
Reference Only