OPERATING CONTROLS AND PROCEDURES RT9150E OPERATOR MANUAL
3-6
Published 2-23-2017, Control # 644-00
STEERING COLUMN LEFT SIDE AND 
FLOOR
Refer to Figure 3-2.
Steering Column Tilt/Telescope Lever
The Steering Column Tilt/Telescope Lever (1) is on the steer-
ing column below the turn signal lever. Rotate the lever coun-
terclockwise to loosen the steering column for adjustment.
The steering column can now be tilted or telescoped in and
out. After adjustment tighten the lever by turning clockwise. 
The lever can be re-positioned; push in and rotate to the
desired position then pull the lever out. 
Cup Holder
Location to hold a beverage container (3) (Figure 3-2).
360° Swing Lock Pedal
The 360° Swing Lock Pedal (4) is located to the left of the
swing brake pedal on the left side of the cab floor. The 360°
swing lock secures the superstructure in any position.
When the pedal is up, the swing lock is disengaged and the
superstructure can be rotated. Pushing down on the pedal
engages the swing lock. To disengage the swing lock pull up
on the release lever at the top of the pedal.
Swing Brake Pedal
The Swing Brake Pedal (5) is located on the left side of the
cab floor. The Swing Brake Pedal is used to actuate the
swing brake to slow or stop swing motion. Braking is
proportional to pedal depression. 
Service Brake Foot Pedal
The Service Brake Foot Pedal (6) is the second pedal from
the right on the cab floor. Depressing the pedal controls the
application of the service brakes to stop the vehicle. This
pedal must be depressed to start the engine.
Throttle Pedal
The foot Throttle Pedal (7) is located on the right side of the
cab floor. The pedal is used to control engine speed. The
pedal controls engine speed proportionately to the applied
foot pressure. The pedal is connected electrically to the
engine ECM.
Item Description
1 Steering column tilt/telescope lever
2
Turn Signal Lever:
Windshield Wiper Switch
3 Cup Holder
4 360° Swing Lock Pedal
5 Swing Brake Pedal
6 Service Brake Foot Pedal
7 Foot Throttle Pedal
WARNING
Loss of Control Hazard!
Never operate the crane with the steering column
adjustment lever loose. Serious injury or property damage
may result.
Reference Only