Manitowoc Grove RT9150E - Warning Messages

OPERATING CONTROLS AND PROCEDURES RT9150E OPERATOR MANUAL
3-62
Published 2-23-2017, Control # 644-00
WARNING MESSAGES
ECOS differentiates between warning messages and error
messages, see Error Messages, page 3-66. A warning
message indicates that certain values do not correspond to a
set value.
In the event of a warning message, the following lamps flash:
• the Warning/Error indicator (1) (Figure 3-61)
• the A button lamp (2).
Press the A button (5) next to the flashing lamp to open the
Warning submenu.
The warning message is acknowledged, lamp (2) lights up
(does not flash any longer).
When all warning messages have been acknowledged, lamp
(1) and lamp (2) lights up.
Both lamps start to flash again as soon as a new warning
occurs.
Meaning of the Symbols
The color of the symbols indicate whether a warning
message is active in the corresponding area:
• Symbol grey, no warning message.
• Symbol red, warning message.
Carry out the following procedures if a symbol is displayed in
red.
Exiting the Submenu
You can exit the submenu at any time.
Press the Esc button (1) (Figure 3-62) once. The same menu
opens that was open before the Warnings submenu opened.
If the same warning messages are still present, the lamps (1)
and (2) (Figure 3-61) light up.
If no warning message is present, both lamps will go out.
Both lamps start flashing again as soon as a new warning
message occurs.
FIGURE 3-61
CAUTION
Equipment Damage Hazard!
Keep alert for warning messages. When warning
messages appear take appropriate action to prevent
malfunction and possible damage to the crane.
FIGURE 3-62
Reference Only