Masimo Root User Manual

Root NIBPT Chapter 16: Service and Maintenance
www.masimo.com 158 Masimo
8. To begin the overpressure test, press the Test button, then increase the pressure
to the overpressure point:
• Increase pressure to approximately 280mmHg using the hand bulb.
• Very slowly increase the pressure as you approach the overpressure point.
• When the overpressure point is reached, the valves will open (a faint click
can be heard when this occurs) and the pressure will rapidly reduce to 0
(zero) mmHg. Be sure to observe the pressure measurement on the
manometer when the valves open.
9. Determine if the NIBP module passed the overpressure test:
• If the valves opened WITHIN the overpressure pass criteria, then the NIBP
module PASSED the overpressure test for adults and pediatrics. Go to step
10.
• If the valves opened BEYOND the overpressure point pass criteria, then press
the Test button again to confirm the overpressure point. If the valves open
repetitively beyond the pass criteria, contact Masimo Technical Services. See
Masimo Technical Services on page 160.
10. To stop testing, press Stop.
11. Disconnect the manometer, 500mL bottle or cuff wrapped around solid object,
and hand bulb from the NIBP module.
12. Power OFF the manometer.
Test Method for Neonates
1. Follow steps 1 through 3 from Test Method for Adults and Pediatrics above.
Note: If using a cuff, verify the cuff is Neonate. Do not use an Adult or Pediatric cuff
for this test method.
2. On the Root Main Screen, touch the Profiles option in the Status Bar. See About
the Status Bar on page 34.
3. Select Neonates in the Profiles screen, then touch OK.
4. Start the NIBP measurement then immediately abort:
• Touch the Start NIBP button.
• Touch the Start NIBP button again when then pump starts to inflate the
system.
5. Press the Main Menu icon
6. Press NIBP .
7. Press CALIBRATION .
• For the password, enter 4258.
• Press the Enter key.
8. Press OVERPRESSURE TEST .
9. To begin the overpressure test, press the Test button, then increase the pressure
to the overpressure point:

Masimo Root Specifications

General

Category	Medical Equipment
Display	10.1 inch touchscreen
Connectivity	WiFi, Bluetooth
Power Supply	AC power
Dimensions	26.8 cm x 22.4 cm x 5.1 cm
Ports	USB, Ethernet
Supported Parameters	SpO2, Pulse Rate
Compatibility	Masimo sensors
Model	Root