Root NIBPT Chapter 2: Setting Up
www.masimo.com 31 Masimo
Attach the Temperature Probe
1. Hold the temperature probe cable connector with the spring tab on the right and
insert it into the probe port of the temperature module.
2. Push the cable connector into place until it clicks.
3. Place probe cover onto the temperature probe and dock in the probe well.
Attach NIBP Cuff
For a list of compatible NIBP patient hoses and cuffs, visit http://www.masimo.com/.
1. Attach an adapter to the end of the cuff hose (if necessary).
2. Connect blood pressure cuff to the NIBP Nib located on the side of Root. See
Chapter 5: NIBP Measurement on page 93.
Masimo Kite
Masimo Kite Software Application is a passive monitoring interface to Point-of-Care (POC)
Masimo medical devices (Root for example) that co-exist under the same Wi-Fi network. Kite
remotely displays system and parameter status reported by the POC device on a separate
monitor.
Root must be on the same network as Kite.
Note: If the device is not on the same network, it can be added, but Kite will not be able to
connect it to view the parameters monitored by that device until both Kite and the device are
connected to the same network.
To add Root to Kite to view parameter status, refer to the Masimo Kite Software Application
Operator's Manual.
Bluetooth Devices
External devices can be connected to Root through Bluetooth. For more information about
connecting an external device to Root through Bluetooth, see Chapter 12: Bluetooth Devices
on page 123.
To Next Page
Loading...
Need help?
General
