Matrot M24D Hellios - Configuration (Access Code 1111)

100 2011
User notice
M24D Hellios
V 1.0
15.2.7. Conguration (Access code 1111)
Congurationmodecanbeusedtoadjustorchangevariousdisplayparameters.
Thisincludes"metric/imperial"units,ortheintervalbetweentwooverhauls,etc.
Conguration mode can be obtained by pressing key 5 for at least 3 seconds when the display is in normal
operatingmode.
Thecongurationmenuwhichappearsonthescreenisshownbelow.
Keys1and2canbeusedtoselectthe"settingorsystem"menu,key4canbeusedtoenterthehighlightedmenu.
Key5canbeusedtoquitthemenuandconrmmodicationstoanon-volatilememory.
Theauxiliarymenu,"SETTINGS",canbeusedtocongurethedisplaybasedonuserpreferences.
SelectUNITSfromtheSETTINGSmenutoaccess5parameterswhichcanbedisplayedwiththeunitsselected
fromthelist.Usekeys1and2toselectaparameterandthenpresskey4toscrollthroughthedifferentunits
available.Presskey5toconrmandquitthemenu.
TheLANGUAGEmenucanbeusedtoselecttherequiredlanguage.Presskeys1and2togototherequired
language,andthenpresskey4toselect,followedbykey5toconrmtheselectedlanguageandquitthemenu.
TheBLEEPmenucanbeusedtoactivateaBeepwhenthedifferentkeysarepressed.NOTE:eveniftheBLEEP
isde-activated,anaudioalarmwillbetriggeredforan"alarm"enginefailure.
TheDISPLAYmenucanbeusedtodenethemax.speeddisplayedonthetachometer,themax.speeddisplayed
(notused)onthespeedindicatorandthetimespanbetween2pointsdisplayedingraphicmode.
TheSERVICEmenucanbeusedtodeneaperiodbetweentwooverhauls.Thedisplaywillinformtheoperator
whenanoverhaulisrequired.Enter0hourstode-activatethisfunction.
Aftertheoverhaul,thetechnicianmustpressonthemiddlekeyforatleast2seconds(untilabeepisheard)and
theservicealarmwillthenbede-activateduntilthetimeintervalprogrammedbetweentwooverhaulsisonce
againexceeded.Toreturntothemainmenu,presskey5severaltimes.
Toremovethisalarm,gotocongurationmode,selectserviceandenter0hours.