Matrot M24D Hellios - III. CONTROLS

20 2011
User notice
M24D Hellios
V 1.0
III. CONTROLS
1 Parking brake lever
2 Spray pump speed adjuster knob
3 Windscreen washer tank
4 Engine control screen
5 Alternator charge indicator
6 Parking brake indicator
 7 Airltercloggingindicator
8 Speed range 1 indicator
9 Speed range 2 indicator
10 Left turning indicator light
11 Switch: turning indicators, horn, low beam – full beam
12 Control pedal
13 Engine incident troubleshooting indicator
14 Hydraulicuidlevelindicator
15 Combustion engine pre-heating indicator
16 Low beam indicator
17 Full beam indicator
18 Right turning indicator light
19 Combustion engine cutout/ignition key contact
20 Emergency brake pedal
21 Fuel gauge
22 and 48 Right boom
23 and 33 Left boom
24 Main boom cross-section
25 Slope correction
26 and 32 Front frame lift and descent
27 Joystick
28 Boom section switches
29 Travelstopindicator,controlvalveclosed(positionR10)
30 Travelstopindicator,controlvalveopen(positionR0)
31 Boom command main ON/OFF switch
34 Extending / retracting the outer left arm
35 Extending / retracting the main arms
36 Boomsafetydevicelock/releasecontactor
37 Speed range 1 / 2 control switch
38 Rearjettankresidualvolumedrainagepumpswitch
39 Tankresidualvolumedilutionpumpswitchinthecab
40 Rear power switch
41 Left lateral jet switch
42 Right lateral jet switch
43 Rear steering controls
44 Rear steering power switch
45 Boom arm control switches
46 Extending / retracting the outer right arm
47 Gear stick
50 Main spray operation indicator
51 Solenoidvalvecontrol–mixing/residualvolumeinthetank
52 Centrifugal pump ON/OFF control
53 Engine accelerator
54 "Teejet 860" control panel
55 DGPS module*
56 12 V plug
57 Deutz engine troubleshooting socket
58 Hazard lights switch
59 Glovebox