EasyManua.ls Logo

Matrot M24D Hellios - VI. MAINTENANCE; 6.1. Hydrostatic transmission

Default Icon
102 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
46 2011
User notice
M24D Hellios
V 1.0
1
VI. MAINTENANCE
6.1. Hydrostatic transmission
6.1.1. Filtration Filtration
Suction filter between the tank and pump.
In normal operating conditions, the filter must be replaced at the following intervals:
50 operating hours after initial start-up
1
400 operating hours after initial start-up
And then: refer to the maintenance log for the M24D Hellios
Filter cartridge reference: 161 209 000
The filter cartridge must be changed with the combustion engine stopped.
To replace the cartridge:
unscrew the cartridge using a strap wrench,
clean the surface of the filter casing seal,
fill the cartridge with fresh oil,
rescrew the new cartridge on firmly (add oil to the seal).
Only original MATROT ÉQUIPEMENTS parts are covered by the warranty of your self-propelled
machine.
1
e self-propelled machine is delivered with a lter cartridge with a life cycle of 50 hours.
Filling of the
hydraulic fluid tank
Minimum level
detection probe
Hydraulic fluid level

Table of Contents