36 2011
User notice
M24D Hellios
V 1.0
5.4.3. Stopping the engine
◦Do not cut the engine suddenly when running at full load, allow the engine to run at low speed for a
few minutes to allow temperatures to balance.
◦Turn the ignition key to the left.
◦Remove the ignition key.
◦Wait for 10 seconds or more and then activate the cutout switch.
IMPORTANT
Wait for at least 10 seconds after stopping the engine before activating the cutout switch.
The computer will save data whenever the engine is stopped. If this safeguard is not
completed, the program can be damaged.
NEVER STOP THE ENGINE USING THE CUTOUT SWITCH.
10 s.
To Next Page
Loading...