Matrot M24D Hellios - Page 89

2011 89
User notice
M24D Hellios
V 1.0
3
4
5
6
7
10
9
15
8
14
11
16
12
17
13
20
19
18
Rinsing the main tank
The main tank is empty
The water rinsing tank
1. Rotate the valves to position 5 C ③
2. Engage the pump ④
3. Set the combustion engine to mid-power ⑤
As soon as the procedure is complete
4. Reduce engine power ⑥
5. Disengage the pump ⑦
Rinsing the spray system
1. Rotate the valves to position 1 A (Spray) ⑧
2. Activate the manual key
1
⑨
3. Press ⊖ ⑩ until the control valve is completely open. Position of the
external slide valve R 0 ⑪ and travel stop indicator R 0 ⑫ lit up.
4. Set the tank bottom valve to the mixing position ⑬
Main solenoid valve to off
Combustion engine at idle
6. Engage the pump ④
7. Allow to run for a few minutes and then stop the pump
Rinsing the booms
1. Rotate the valves to position 1 C ⑭
2. Activate the manual key on the 860 control panel ⑨
3. Press ⊕ ⑮ until the control valve is completely closed. Position of the external
slide valve R 10 ⑯ and travel stop indicator R 10 ⑰ lit up.
4. If product remains in the main tank (mid-tank): close the flow valves on the
boom
5. Set the tank bottom valve to the mixing position ⑬
6. Engage the pump ④
7. Set the combustion engine to mid-power ⑤
8. Open all sections ⑱
9. Open the main solenoid valve ⑲
When the pump has been primed
10. Set the tank bottom valve to the residual volume position ⑳
If necessary, recover the residual volume, as described
in the paragraph on “Recovering anti-freeze”
IMPORTANT:
Comply with safety instructions and applicable legislation in the
country for the products used.