3-2
1. Open the top panel. (See page 3-1)
2. Remove two T-20 screws, with star
washers, from the front top edge of the
control panel.
3. Grasp left and right ends of control panel.
Lift and pull panel away from the washer.
4. There are rollers, that move through
channels in the control panel brackets on
both ends, which allow the control panel
to be opened and leaned forward, or lifted
and removed from the washer. Position the
control panel with the rollers in the middle
of the channels and lift to remove the rollers
from the channels.
5. Hang the rollers on the hooks at the top
corners, which hold the control panel in the
service position.
NOTE: Below the control panel, on the top
of the front panel, are rubber pads to help
reduce vibration between the panels. If
replacing a panel, make sure to reinstall any
rubber pads in the same locations as on the
original panel.
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before
operating.
OPEN CONTROL PANEL
Two T-20
Screws
Service
Position Hook
Roller
Channel
Roller
Rubber
Pad
To Next Page
Loading...
Need help?
General
