3-34
6. Pull the glass bowl and seal away from the
inside edge of the door to remove them.
7. To remove the seal, pull the front edge of
the seal over the edge of the glass bowl.
8. Slide the seal down the inside edge of the
glass bowl and remove it.
9. For reinstallation, install the seal around the
edge of the glass bowl.
10. Set the bottom edge of the glass bowl
and seal onto the bottom edge of the door
opening with the lip of the seal over the
edge of this opening.
11. Push the lip of the seal through the
opening, to the front of the door, all the way
around the glass bowl.
12. Push the glass bowl to seat the seal in the
door opening.
DOOR GLASS BOWL AND SEAL
1. To remove the door glass bowl and seal,
open the washer door.
2. Use a flat blade screwdriver to slide behind
the rubber seal and fold it down away from
the front of the door.
3. Push the screwdriver up between the inside
edge of the door and the seal.
4. Slide the screwdriver approximately one
third of the way around the door opening to
separate the seal from the door.
5. From the inside of the door, grasp the glass
bowl and seal through the area separated
with the screwdriver.
To Next Page
Loading...
Need help?
General
