3-37
21. Verify that the hook of the shaft springs
back to the proper position that matches the
orientation of the hole in the front plate of
the washer.
22. Close and latch the door.
23. Verify that the handle latches and ratchets
in the close direction.
24. Unlatch and open the door.
25. Verify that the handle ratchets while
turning further in the open direction.
18. Reinstall the front cover ring, with the ridge
facing the inside of the cover.
19. Reinstall front cover, by aligning channels
of the knob with the slots in the cover.
20. Snap the cover into position.
To Next Page
Loading...
Need help?
General
