Mazda 6 2009 - 00 General Information; Default Chapter; Table of Contents; Toc of SCT

00
GENERAL INFORMATION
00-00–1
SECTION
00-00
Toc of SCT
GENERAL INFORMATION . . . .00-00
Toc of SCT
00-00 GENERAL INFORMATION
VEHICLE IDENTIFICATION NUMBER
(VIN) CODE . . . . . . . . . . . . . . . . . . . . . . 00-00–2
2009 MY . . . . . . . . . . . . . . . . . . . . . . . . 00-00–2
2010 MY . . . . . . . . . . . . . . . . . . . . . . . . 00-00–3
VEHICLE IDENTIFICATION NUMBERS
(VIN) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 00-00–3
2009 MY . . . . . . . . . . . . . . . . . . . . . . . . 00-00–3
2010 MY . . . . . . . . . . . . . . . . . . . . . . . . 00-00–3
HOW TO USE THIS MANUAL . . . . . . . . . 00-00–4
Efficient Replacement of
Body Panels . . . . . . . . . . . . . . . . . . . . 00-00–4
Symbols of Panel Replacement . . . . . . 00-00–4
Body Dimensions
(Flat-plane Dimensions) . . . . . . . . . . . 00-00–5
Body Dimensions
(Straight-line Dimensions) . . . . . . . . . 00-00–6
Symbols of Body Dimensions . . . . . . . . 00-00–9
AIR BAG SYSTEM
SERVICE WARNINGS . . . . . . . . . . . . . . 00-00–9
Air Bag Module Inspection . . . . . . . . . . 00-00–9
Air Bag Module Handling . . . . . . . . . . . 00-00–9
Side Air Bag Module Handling . . . . . . . 00-00–10
SAS Control Module Handling . . . . . . . 00-00–10
Side Air Bag Sensor Handling. . . . . . . . 00-00–10
Pre-tensioner Seat Belt Inspection . . . . 00-00–10
SERVICE PRECAUTIONS . . . . . . . . . . . . 00-00–11
Arrangement of Workshop . . . . . . . . . . 00-00–11
Safety Precautions . . . . . . . . . . . . . . . . 00-00–11
Vehicle Protection . . . . . . . . . . . . . . . . . 00-00–11
Remove Dangerous Articles . . . . . . . . . 00-00–11
Use of Pulling Equipment . . . . . . . . . . . 00-00–12
Prevent Short Circuits . . . . . . . . . . . . . . 00-00–12
EFFICIENT REMOVAL OF
BODY PANELS . . . . . . . . . . . . . . . . . . . 00-00–12
Body Measurements . . . . . . . . . . . . . . 00-00–12
Prevention of Body Deformation. . . . . . 00-00–13
Selection of Cut-and-join Locations . . . 00-00–13
Removal of Associated Parts . . . . . . . . 00-00–13
Rough Cutting of Damaged Panel . . . . 00-00–13
EFFICIENT INSTALLATION OF
BODY PANELS . . . . . . . . . . . . . . . . . . . 00-00–13
Checking Preweld Measurements And
Watching . . . . . . . . . . . . . . . . . . . . . . 00-00–13
Welding Notes . . . . . . . . . . . . . . . . . . . 00-00–14
Spot Welding Notes . . . . . . . . . . . . . . . 00-00–14
Checking Weld Strength. . . . . . . . . . . . 00-00–15
INSTALLATION PREPARATIONS. . . . . . 00-00–16
Rough Cutting of New Parts. . . . . . . . . 00-00–16
Determination of Welding Method . . . . 00-00–16
Making Holes for CO
2
Arc Welding . . . 00-00–16
Application of Weld-through Primer . . . 00-00–17
ANTICORROSION, SOUND INSULATION,
AND VIBRATION INSULATION . . . . . . 00-00–17
Body Sealing . . . . . . . . . . . . . . . . . . . . 00-00–17
Application of Undercoating . . . . . . . . . 00-00–17
Application of Rust Inhibitor . . . . . . . . . 00-00–18
Application of Floor Silencer. . . . . . . . . 00-00–18
BODY COLORS. . . . . . . . . . . . . . . . . . . . 00-00–18
Color Code and Color Name . . . . . . . . 00-00–18
Verification of Primary Color Mixture for
Body Color . . . . . . . . . . . . . . . . . . . . . 00-00–18
ABBREVIATION . . . . . . . . . . . . . . . . . . . 00-00–18
IDENTIFICATION NUMBER
LOCATIONS . . . . . . . . . . . . . . . . . . . . . 00-00–19
Vehicle Identification Number (VIN) . . . 00-00–19
Engine Identification Number. . . . . . . . 00-00–19
End of Toc
BM: GENERAL INFORMATION
3442-1U-09G.book 1 ページ ２００９年７月２２日 水曜日 午前１１時７分