21 INSTALLATION AND CONFIGURATION
3021M100-002
21-15
configure the software that resides on the CX950’s motherboard or monitor its I/
cards’ traffic.
21.7 Powering Up
This procedure assumes that you have connected the CX950 to its power source, and
have also connected its I/O cards to their network devices.
Procedure 13: Powering Up CX950
To power up the CX950:
1. Locate the power switch on the rear panel.
2. Depress the power switch to the ON position.
3. Check the POWER/STATUS LED on the front panel.
4. If the LED does not light, proceed to Procedure 14. If the LED is flashing,
arrange through your sales representative to return the unit to the factory for
repair or replacement. Otherwise proceed with configuring/monitoring the
CX950 as described in the
CXTool User Guid
, part no. 3008M300-001
.
Procedure 14: Checking/Replacing CX950 Fuses
This procedure assumes the POWER LED did not light when you powered up the
CX950. It further assumes that power is present at the source and that the power
cord was properly connected between the source and the CX950.
To check and, if necessary, replace the CX950’s fuses:
1. Locate the power entry module on the rear panel.
2. Push the power switch to the OFF position and disconnect the power cord
from the CX950.
3. Gently pry the fuse bank out of the power entry module.
4. Remove the fuses from the fuse bank and examine them for signs of having
blown.
5. If the fuses have blown, replace them, then return the fuse bank to the power
entry module and proceed to Procedure 13. If they have not blown, arrange
through your sales representative to return the unit to the factory for repair or
replacement.
To Next Page
Loading...
Need help?
General
