MICRO-EPSILON ILD1402-5 User Manual

Page 10
Laser Class
optoNCDT 1402
During operation of the sensor the pertinent regulations acc. to EN 60825-1 on „radiation safety of laser
equipment“ must be fully observed at all times. The sensor complies with all applicable laws for the manufac-
turer of laser devices.
laser on
state
teach in
optoNCDT
Laser spot Laser spot
LASER RADIATION
Do not stare into the beam
CLASS 2 LASER PRODUCT
IEC 60825-1: 2007
3P:O=670 nm
True reproduction of the sensor with its actual location of the warning labelsFig. 1:
Laser operation is indicated by LED.
Although the laser output is low looking directly into the laser beam must be avoided. Due to the visible light
beam eye protection is ensured by the natural blink reflex.
The housing of the optical sensors optoNCDT1402 may only be opened by the manufacturer (see Chap. 11).
For repair and service purposes the sensors must always be sent to the manufacturer.
Do not look directly into
the laser beam!
Possible injury of the
eyes. Close your eyes
or turn away promptly
if laser radiation strikes
your eyes.

MICRO-EPSILON ILD1402-5 Specifications

General

Brand	MICRO-EPSILON
Model	ILD1402-5
Category	Measuring Instruments
Language	English