Page 75
Warranty
optoNCDT 1402
Warranty 13.
All components of the device have been checked and tested for perfect function in the factory. In the unlikely
event that errors should occur despite our thorough quality control, this should be reported immediately to
MICRO-EPSILON.
The warranty period lasts 12 months following the day of shipment. Defective parts, except wear parts, will be
repaired or replaced free of charge within this period if you return the device free of cost to MICRO-EPSILON.
This warranty does not apply to damage resulting from abuse of the equipment and devices, from forceful
handling or installation of the devices or from repair or modifications performed by third parties.
No other claims, except as warranted, are accepted. The terms of the purchasing contract apply in full.
MICRO-EPSILON will specifically not be responsible for eventual consequential damages. MICRO-EPSILON
always strives to supply the customers with the finest and most advanced equipment. Development and re-
finement is therefore performed continuously and the right to design changes without prior notice is accord-
ingly reserved. For translations in other languages, the data and statements in the German language opera-
tion manual are to be taken as authoritative.
Service, Repair 14.
In the event of a defect on the sensor or sensor cable,
the parts concerned must be sent back for repair or
replacement. In the case of faults the cause of which is
not clearly identifiable, the whole measuring system must
be sent back to
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Königbacher Straße 15
94496 Ortenburg
Tel. 08542/168-0
Fax 08542/168-90
e-mail info@micro-epsilon.de
www.micro-epsilon.com
Decommissioning, Disposal 15.
Disconnect the power supply and output cable on the sensor.
The disposal is done according to the legal regulations.
To Next Page
Loading...
Need help?
General
