Page 8
Safety
optoNCDT 1402
CE Compliance1.3
The following applies to the optoNCDT1402: EMC regulation 2004/108/EC
Products which carry the CE mark satisfy the requirements of the EMC regulation 2004/108/EC ‘Electromag-
netic Compatibility’ and the European standards (EN) listed therein. The EC declaration of conformity is kept
available according to EC regulation, article 10 by the authorities responsible at
MICRO-EPSILON Messtechnik GmbH & Co. KG
Königbacher Straße 15
D-94496 Ortenburg
The sensor is in compliance with the following standards
EN 61326-1:2006 / EN 55011 Class B Spurious emission -
EN 61326-1:2006 / EN 61000-6-2 Immunity to EMI -
The sensor fulfills the specification of the EMC requirements, if the instructions in the operating manual are
followed.
Proper Use1.4
The series optoNCDT1402 measuring system is designed for use in industrial areas. -
It is used -
for measuring displacement, distance, position and thickness
for in-process quality control and dimensional testing
The measuring system may only be operated within the limits specified in the technical data (Chap. 3.3). -
The sensor should only be used in such a way that in case of malfunctions or failure personnel or machi- -
nery are not endanged.
Additional precautions for safety and damage prevention must be taken for safety-related applications. -
Proper Environment1.5
Protection class sensor: IP 67 -
Optical surfaces are excluded from protection class. Contamination of the lenses leads to impairment or -
failure of the function.
To Next Page
Loading...
Need help?
General
