Microm TX3 Series - Figure 20 Surface Mounting the Enclosure

To Next Page

To Previous Page

Enclosure Installation

Version 3.4 TX3 Touch Screen Installation Manual 33 (93)

2. Using the surface mount enclosure as a template, mark the back mounting

hole locations of the two keyholes as shown in Figure 20. Ensure that at

least one side is over a wall stud.

Figure 20 Surface mounting the enclosure

3. Remove the enclosure and place the top two fasteners halfway into the

marked hole locations and wall stud.

4. Place the enclosure onto the two fasteners and lower it so that the fasteners

fit in the narrow part of the keyholes.

5. Screw the other four fasteners into the four remaining holes.

6. Tighten all six fasteners into place.

7. Close the door until it clips into place.

2.5.2 Installing the Flush Mount Enclosure

The flush mount enclosure mounts directly inside the wall to the wall stud or

supporting structure. Mount the enclosure flush with the wall and right-side up

(the Mircom logo on the door is on the bottom).

Keyhole Keyhole

screw

All manuals and user guides at all-guides.com