Microm TX3 Series - Shutting Down the Touch Screen

68 (93) TX3 Touch Screen Installation Manual Version 3.4
Copyright 2015 LT-996
Touch Screen System and Setup
DIP Switch 8 on SW1 determines how the Telephone Access Controller board
gets its IP address (only for for IP-enabled Touch Screen models with the TX3-IP
Module installed):
• DIP Switch 8 OFF: The IP address is assigned by a DHCP server.
• DIP Switch 8 ON: The IP address is assigned using the TX3 Configurator
software.
The Touch Screen controller is now ready for configuration. For a complete
description of the configuration and on how establish a connection to the Touch
Screen, see the following documentation:
• LT-995 Configuration and Administration Guide
• LT-973 TX3 Configurator Quick Start
3.12 Shutting Down the Touch Screen
3.12.1 Shutting down the 15” Touch Screen
To shut down the TX3 unit from the touch screen software, perform the following
steps.
Note: Never turn off power when the system is operational.
1. At the Touch Screen terminal, enter 9999.
2. Enter your administrator password, and then press OK.
3. Select File > Shut down > Shut down.
Do not disconnect the power until the full shut down process has been
completed.
3.12.2 Shutting down the 22” Touch Screen
Note: Never turn off power when the system is operational.
1. At the Touch Screen terminal, enter 9999.
2. Enter your administrator password, and then press OK.
3. Select File > Shut down > Shut down.
All manuals and user guides at all-guides.com