Chapter 4 Helpful Tips
123
Item
Setting
*1
Details
AutoIP ON/OFF Select "ON" to use the IP address set by the
AutoIP protocol. Note that DHCP takes priority if
DHCP is set to "ON".
IP Address - Sets the machine's IP address.
• This can be set when both [DHCP] and
[AutoIP] are set to "OFF".
Def.Gateway - Sets the machine's gateway.
• This can be set when both [DHCP] and
[AutoIP] are set to "OFF".
DNS Address - Sets the machine's DNS server address.
• This can be set when both [DHCP] and
[AutoIP] are set to "OFF".
Sub Net Mask - Sets the number of subnet mask digits used by
this machine.
• This can be set when both [DHCP] and
[AutoIP] are set to "OFF".
*1. The default settings are shown underlined.
1
Press the [FUNCTION] key in local mode.
2
Use to select [SET UP], then press the [ENTER/HOLD] key.
3
Use to select [NETWORK], then press the [ENTER/HOLD] key twice.
• The machine's current IP address is displayed. "Info" is displayed at the top right.
• It may take some time after connecting to the network to determine the IP address. If the IP
address cannot be acquired, the display will indicate "0.0.0.0".
4
Press the [ENTER/HOLD] key.
5
Use to select [MAC Address], then press the [ENTER/HOLD] key.
• Displays the machine's current MAC address.
• Press to display the next address.
6
Press the [ENTER/HOLD] key.
7
Use to select [DHCP], then press the [ENTER/HOLD] key.
• Use to enable or disable.
• Select "ON" to use the IP address assigned by the DHCP server.
8
Use to select [AUTO IP], then press the [ENTER/HOLD] key.
• Use to enable or disable.
• Select "ON" to use the IP address set by the AutoIP protocol. Note that DHCP takes priority if
DHCP is set to "ON".
9
If both DHCP and AutoIP are disabled, use to select the following item, then press the
[ENTER/HOLD] key. In all other cases, press the [END] key several times to exit.
• Setting items: IP Address ("Info" is not displayed at the top right of the display), Def.Gateway, DNS
Address, SubNet Mask
4
To Next Page
Loading...
Need help?
General
