MIMAKI CG-AR Series User Manual

Chapter 3 Cutting Data with Register Marks
97
3.5 ID Cut Process
• For more information, refer to the ID Cut Guide. https://mimaki.com/download/software.html
For information on the ID cut register mark scanning range, refer to "This machine can detect register
marks in the range shown in the above figure."(P. 83).
1.
Create data with ID Cut.
2.
Print printing data with ID Cut.
3.
Prepare for cutting.
"Cutting Process"(P. 42) (Steps 1 to 8)
4.
Register the information for the printed register marks.
"Setting Register Mark Detection Conditions"(P. 85)
5.
Detect register marks.
"Detect register marks."(P. 89)
6.
Cut the data.
"Cut the data."(P. 73)
7.
Separate sheets.
"Separating Sheets (Manual Cutting)"(P. 75)
3

MIMAKI CG-AR Series Specifications

General

Brand	MIMAKI
Model	CG-AR Series
Category	Plotter
Language	English