Chapter 2 Cutting
This chapter
Describes cutting procedures and setting methods.
Cutting Process ...............................................42
Loading a Sheet ..............................................44
Loading a Leaf Sheet (Cut Sheet).............. 47
Loading a Roll Sheet (CG-60AR)............... 48
Loading a Roll Sheet (CG-100/130AR)...... 52
Pinch Roller Position/Number and Clamp
Settings ...................................................... 55
Installing Tools ................................................59
Using the Cutter ......................................... 59
Using a Pen................................................ 63
Using the Creasing Tool............................. 67
Selecting Tool Conditions.................................68
Setting Tool Conditions ....................................69
Test Cutting ......................................................72
Cut the data......................................................73
Setting the Origin .........................................73
Starting Cutting ............................................73
Pausing Cutting............................................74
Aborting Cutting (Data Clear).......................74
Retracting the Carriage................................74
Separating Sheets (Manual Cutting) ................75
To Next Page
Loading...
Need help?
General
