Chapter 4 Helpful Tips
130
Outputting Received Data as ASCII Code [DUMP]
Data can be sent from the host computer and printed as ASCII code.
Dumping is possible via an interface to which the host computer is connected.
1
Change the tool to a pen.
• "Using a Pen"(P. 63)
2
Press the [FUNCTION] key in local mode.
3
Use to select [ASCII DUMP], then press the [ENTER/HOLD] key.
• The dump contents cannot be checked directly on a computer.
• To abort dumping, press the [REMOTE] key to switch to local mode, then clear the data.
"Aborting Cutting (Data Clear)"(P. 74)
• When dumping, use sheet detection with rear loading. "Note about sheet
detection"(P. 45)
Selecting the Screen Display Language [DISPLAY]
The language displayed on the screen can be selected. (Initially it is set to "English".)
• Available languages:
Japanese, English, German, French, Spanish, Italian, Portuguese, Chinese, Korean, Thai, Russian
1
Press the [FUNCTION] key in local mode.
2
Use to select [DISPLAY], then press the [ENTER/HOLD] key.
3
Use to select the display language, then press the [ENTER/HOLD] key.
4
Press the [END] key several times to exit.
Checking Machine Information [INFORMATION]
It is possible to check information relating to the machine.
The following information can be checked:
Item Details
MODEL Checks the machine model.
F/W ver. Checks the machine firmware version.
SERIAL No. Checks the machine serial number.
IP Address Checks the machine IP address.
1
Press the [FUNCTION] key in local mode.
2
Use to select [INFORMATION], then press the [ENTER/HOLD] key.
3
Use to select the machine information to be displayed, then press the [ENTER/HOLD]
key.
• The corresponding information is displayed.
To Next Page
Loading...
Need help?
General
