Chapter 2 Cutting
55
12
Check to confirm that the pinch rollers are evenly spaced.
• Hold the sheet between the pinch rollers and grit rollers.
• If the spacing is not uniform, repeat all steps from the start.
13
Unlock the roll stopper
• Pull the roll stopper lever toward the front of the machine while pressing in.
14
Press or to select [ROLL].
• Note about sheet detection "Note about sheet detection"(P. 45)
• : If the roll sheet was loaded at the rear of the machine
• : If the roll sheet was loaded at the front of the machine
• Pressing the [FEED] key displays a screen for selecting the number of pinch rollers before
sheet detection. Select the number of pinch rollers before performing sheet detection.
• The number of pinch rollers set here takes precedence over the number of pinch rollers
using the [SET UP] - [PINCH ROLL.] menu.
15
Press to select the number of pinch rollers to be used.
• If [ROLL. SELECT] is set to [ON], select the number of pinch rollers to be used. "Setting the
Number of Pinch Rollers to Use"(P. 56)
16
Start sheet detection.
• If [DUMMY CUT] is set to [ON], a dummy cut is performed after sheet detection is complete.
"DUMMY CUT"(P. 140)
17
Use [FEED] to pull out the length of sheet to be used. "Sheet Feed"(P. 119)
• Before using the roll sheet, make sure that there is sufficient sheet for the length to be
used. Feeding the sheet reduces offset when cutting and also allows you to check in
advance that the sheet is not askew.
Pinch Roller Position/Number and Clamp Settings
Moving the Pinch Rollers
Move the pinch rollers by hand above the appropriate grit rollers to suit the width of the sheet to be loaded.
Be sure to push the clamp lever to the rear to separate the pinch rollers from the grit rollers before moving
them.
The range over which the pinch rollers can be moved is as follows. Use the pinch rollers positioned within
the pinch roller marks.
2
To Next Page
Loading...
Need help?
General
