Chapter 4 Helpful Tips
106
4.3 Cutting Multiple Copies of the Same
Data [No. COPIES]
You can cut the data stored in the receive buffer of the machine by the specified number (up to 999 sheets).
• The last cutting data is stored in the receive buffer. When new data is received, the already saved data is
overwritten.
• Reset the origin before executing [No. COPIES]. Failure to do so will result in overlap cutting.
Multiple sheet cutting
end origin
Multiple sheet cutting
start origin (set
manually)
Last cut data
(stored in the receive buffer)
Interval between images
Interval between
images
• The machine cuts the specified number of sheets of the divided cut data without separating the
data.
• If you are using , deselect the [Sheet Feed Origin Renewal] checkbox. (This is unselected by
default.)
• [No. COPIES] cannot be executed if the cut data contains an origin renewal command.
• When sending the cut data from the PC, wait for at least 5 seconds before sending the next
data. If the next data is sent within 5 seconds, both pieces of data may be copied. (This time
period can be altered using the close time setting.)
• Data will not be cut if the origin updated within the machine does not lie within the available
cutting area while two-point line correction is being set. "Note about the cutting area"(P. 44)
To Next Page
Loading...
Need help?
General
