Chapter 1 Before Using This Machine
25
Rear
No. Name Outline
1 Clamp pressure lever Selects high or low pressure to clamp the sheet. "Clamp"(P. 28)
"Setting the Clamp High/Low Mode"(P. 57)
2 Center clamp on/off
lever
Enables and disables the center clamp. Disabling the center clamp offers
the following benefits: "Enabling and Disabling the center clamp"(P. 57)
• No marks are left on the sheet.
• Prevents the sheet from lifting up.
3 SHEET sensor Detects whether a sheet is present and detects the sheet length.
"SHEET sensor"(P. 28)
4 Tray Tray used for placing small items such as retractable knives and various
types of cutters. "Tray"(P. 29)
5 Roll stopper
(CG-100/130AR only)
Prevents the roll sheet from rotating when loading a sheet. "Loading a
Roll Sheet (CG-100/130AR)"(P. 52)
(The legs are options available separately for the CG-60AR.)
6 Roll bars A roll sheet is loaded on top of the two bars. "Loading a Roll Sheet
(CG-100/130AR)"(P. 52)
(The legs are options available separately for the CG-60AR.)
7 Roll holder
(CG-100/130AR only)
Clamps the two ends of a roll sheet. ""(P. 53)
8 RS-232C interface
connector
An RS-232C interface connector. "Using an RS-232C Cable"(P. 34)
1
To Next Page
Loading...
Need help?
General
