MIMAKI CG-AR Series User Manual

Chapter 2 Cutting
45
[Expand off]
Pinch roller
5mm or more
Front non-plotting
area
20mm
Cut width
Origin
Cut length
Rear non-plotting
area
30mm
* Non-plotting area
Area where cutting is
not possible
Pinch roller
[Expand on]
5mm or more
Front non-plotting
area
10mm
Cut width
Origin
Cut length
30mm
Rear non-plotting
area
l
Note about sheet detection
The jog keys or [END] key can be used to detect the width and length of the loaded sheet.
• When using sheet length detection, if the data indicates a size larger than the actual sheet,
parts protruding beyond the sheet cannot be cut. Without sheet length detection, the cutting
operation will stop as soon as data extends beyond the sheet.
• If sheet sensing is disabled, the same detection (only sheet width detection) as when the [END]
key is pressed will be performed, even if the jog keys are used.
• The maximum detection length to the rear edge of the sheet is 5 m.
l
Sheet detection method
The display appears as follows when a sheet is loaded.
Press the jog keys to suit the orientation of the sheet loaded.
R loading
Sheet loaded from
rear
F loading
Sheet loaded from
front
2

MIMAKI CG-AR Series Specifications

General

Brand	MIMAKI
Model	CG-AR Series
Category	Plotter
Language	English