4-16
6
Clean the cap rubber and cap rubber cover.
• Wipe off the ink sticking to the cap rubber and cap rubber
cover with a clean stick dipped in cleaning solution for
maintenance. Wipe off so that cleaning solution for
maintenance will not remain.
• At this time, the discharge passage is cleaned automatically.
7
Press the key.
8
Fill up the cap with cleaning solution for
maintenance, using a dropper.
• Fill the cap with the cleaning solution just before the solution
overflows from the cap.
9
Press the key.
• The cleaning solution filled in the cap is absorbed.
• The screen on the right is displayed while the cap is left in a
cleaning solution
• It returns to the step2 after the duration.
• Until washing liquid is filled, [COMPLETED (NEXT): ENT] is displayed on the screen.
After the work up to the Step 8 is completed, press the key. If you press the
key before washing liquid is filled, the carriage returns to the original position.
• When nozzle missing is not cleared even after this washing is carried out several times, contact the
distributor in your region or our service office.
Cap rubber
Cap rubber
cover
Fill the liquid.
COMP L ETED ( NEX T ) [ ENT ]
PLEASE WA I T
00 : 00
** CLEAMING **
PLEASE WA I T
To Next Page
Loading...
