MIMAKI JFX200-2531 - Perform Setting to Reduce Stripes between Passes

3-32
Perform setting to reduce stripes between passes
(6) Press the key.
• A screen for setting SMOOTHING.LV will appear.
(7) Press to set the SMOOTHING LV..
• AUTO : A pattern that matches the smoothing level will
be set automatically.
• 5 to 100% :
The MAPS2 effect become strong as the set value
increase, and become weak as the set value
decrease.
(8) Press the key, and then press key.
• A screen for setting CLEAR will appear.
(9) Press to set the CLEAR.
• AUTO : A pattern that matches the print mode will
be set automatically.
• Pattern 1 to 5 : The pattern that you select will be printed.
(10)Press the key.
• A screen for setting TYPE and LV. will appear.
(11)Press to set the TYPE and LV..
• TYPE1 10 to 100% :
Set a value that matches the print mode.
• TYPE2 10 to 100% :
Set a value that matches the print mode.
9
Press the key.
10
Press the key several times to end the setting.
• MAPS2 effect differs depending on image to be printed. Change the printing pattern and
use it after checking effect in advance.
<SPOT >
SMOOTH I NG LV . : AUTO
<SPOT >
SMOOTH I NG LV . : 5 0%
<CLEAR
PATTERN : AUTO
<CLEAR
PATTERN : AUTO
<CLEAR
TYPE / LV . : AUTO
<CLEAR
TYPE / LV . : AUTO
SETUP
MAPS [ ENT ]