MIMAKI JFX200-2531 - Setting Work Change

3-33
1
1
3
Convenient use
5
6
Setting Work Change
Set whether to return to the local mode or keep the remote mode after online drawing.
1
Press the key in LOCAL.
2
Press to select [SET UP].
3
Press the key.
4
Press to select [WORK CHANGE].
5
Press the key.
6
Press to select a set value.
OFF : Stays in remote status after online printing. (When the next
printing data has been received, it will be overprinted.)
ON : After online drawing, the Y bar is retracted, and return to the local.
HOST ： If you specify the "PRINT COUNT" to two or more in the RasterLink6 screen, Y bar is retracted
for each print end and return to the local.
7
Press the key.
8
Press to select a set value.
OFF : Turns OFF the vacuum automatically after online drawing.
ON ： Vacuum stays ON after online drawing.
9
Press the key.
• When the toggle print function is enabled, refer to "Setting automatic area toggling for toggle printing"
in P.3-20 "Starting toggle printing".
• Position Y bar is retracted will be the position that set in P.2-18 “Setting the view position”.
• This setting is enabled while Work Change is ON.
FUNCT I ON
VIEW [ENT]
FUNCT I ON
SETUP [ ENT ]
SETUP
DROP . POS c o r r e c t [ ENT ]
SETUP
WO R K C H A N G E [ E N T ]
WO R K C H A N G E
:OFF
WO R K C H A N G E
:ON
WO R K C H A N G E
VACUUM: OFF [ ENT ]
WO R K C H A N G E
VACUUM: ON [ ENT ]
WO R K C H A N G E ( F < - > R )
MOD E : A U T O [ E N T ]