MIMAKI JFX200-2531 - Changing origin

3-2
Changing origin
The default origin position can be changed.
There are following 2 changing methods.
Changing origin with JOG keys
1
Press in the local.
• The origin setting mode starts
• A red light pointer mark [] is projected on the table or the media.
2
Move the light pointer mark by pressing
.
• Move the light pointer mark to the position to set a new origin.
3
Press the key when the printing origin is
determined.
• The origin is changed.
• When the toggle print function is enabled, refer to "Changing printing origin" in P.3-20 "Starting toggle
printing".
• The setting value for the origin set with the JOG keys is cleared by cutting the power.
Changing with the JOG keys Changing with the ÅgORIGINÅh
in the FUNCTION menu
OR I G I N SET UP
0.0 ----
OR I G I N SET UP
500 . 0 600 . 0
Origin position
(back and forth)
Origin position
(right and left)
** ORIGIN **