3-28
Perform setting to reduce stripes between passes
What is the MAPS Function?
If performing media correction does not resolve feeding stripes, use the MAPS (Mimaki Advanced
PassSystem) function to disperse the pass boundary to make the feeding stripes less visible.
With the JFX200, you can use both the MAPS1 function and the MAPS2 function.
Setting MAPS1 Function
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [MAPS].
4
Press the key.
5
Press to select MAPS1.
•Set Value：MAPS1, MAPS2, OFF
6
Press the key.
• If you selected MAPS2 or OFF in step 5, proceed to step 8.
7
Press to change print speed.
• Set Value:-50 to +50%
• With MAPS1, the printing speed can be adjusted, but depending on the image to be printed, there
may be color changes. With MAPS2, both feeding stripes and color changes can be reduced, but
speed cannot be adjusted. Choose the function based on the image to be printed.
• MAPS1 effect differs depending on the set value of the printing speed. Use it after checking effect in
advance.
• When you speed up the printing speed, it takes shorter time to print. However, MAPS1 effect
becomes weak.
• When you slow down the printing speed, it takes longer time to print. However, MAPS1 effect
becomes strong and feeding stripes become less visible.
• Enabling the MAPS function, slight color change may be found compared to when the MAPS function
disable. Use it after checking effect in advance.
• MAPS may not be effective depending on image to be printed. Use it after checking effect in advance.
• When you change the speed, nozzle recovery effect cannot work in some cases. Use it
after checking.
SETUP
DROP . POS c o r r e c t [ ENT ]
To Next Page
Loading...
