xi
Precautions in Use
CAUTION
Protection against dust Periodic exchange parts
• It is strongly recommended to use the device in
a room that is not dusty.
• When leaving the workshop after the working
hours, be sure to take off any media from the roll
• hanger.If any media is left on the roll hanger,
dust can put on it.
• Store media in a bag.Wiping off dust
accumulated on a media will adversely affect the
media due to static electricity.
• Dust in the head will also cause drops of ink to
fall abruptly down on the media during printing.If
this phenomenon takes place, be sure to clean
up the head. ( P.2-15)
• There are some parts which must be replaced by
service men.You have to make a contract with
distributors or dealers for after-sale service.
Keep the machine flatly
• Be sure to adjust the level foot to keep the
machine flatly.
Handling of maintenance liquid
• Be sure to store the maintenance liquid in a cold
and dark place.Store the maintenance liquid in a
place that is out of the reach of children.
Warning labels Note on maintenance
• This device is adhered with a warning label. Be
sure understand firmly the warnings given on the
labels.In the case where any of the warning label
has become so soiled that the warning message
is illegible or has come off, purchase a new one
from your local distributor or our office.
• When cleaning parts such as the head, wiper, or
cap, make sure to wear the attached gloves.
Handling the Anti-freezing liquid Power supply
• Be sure to store the Anti-freezing liquid in a cold
and dark place.
• Store the Anti-freezing liquid in a place that is out
of the reach of children.
• Leave the breaker turned ON.
• Do not turn off the main power switch on the
right side of this machine.
Handling of ink bottles
• Use the JFX200 genuine ink. Remember that the user shall be filled for a repair to correct any damage
resulting from the use of ink other than the exclusive type.
• The machine does not operate with any ink other than the JFX200 genuine ink.
• Do not use the JFX200 genuine ink with other printers, as doing so may cause damage to such machines.
• Do not refill ink other than the one specified by our company in the bottle. We are not responsible for any
defects caused by your using such an ink.
• If the ink bottle is moved from a cold place to a warm place, leave it in the room temperature for three hours or
more before using it.
• Open the ink bottle just before installing it in the machine. If it is opened and left for an extended period of time,
normal printing performance of the machine may not be ensured.
• Make sure to store ink bottles in a cool and dark place.
• Store ink bottles and waste ink tank in a place that is out of the reach of children.
• Be sure to thoroughly consume the ink in the ink bottle, once it is opened, within three months. If an extended
period of time has passed away after opening the ink bottle, printing quality would be poor.
• Neither pound the ink bottle nor shake it violently, as doing so can cause leakage of ink.
• Do not touch or stain the contacts of the IC chip, as doing so may cause damage to the print circuit board.
• Waste ink is equivalent to waste oil of industrial waste. Request an industrial waste disposal company for
disposal of waste ink.
Handling of media
• Use media recommended by MIMAKI to ensure reliable, high-quality printing.
• Pay attention to the expansion and contraction of the media.
Do not use media immediately after unpacking. The media can be affected by the room temperature and
humidity, and thus it may expand and contract. The media have to be left in the atmosphere in which they are
to be used for 30 minutes or more after unpacked.
• Do not use curled media.
The use of curled media can not only cause a media jam but also affect print quality. Straighten the sheet of
media, if significantly curled, before using it for printing. If a regular-sized coated sheet of media is rolled and
stored, the coated side has to face outside.
To Next Page
Loading...
