1-11
1
Before Use
3
4
5
6
Setting ink bottles
1
Take out the ink bottle, and slowly shake it twenty times and more.
• To prevent ink from leaking when you shake it, wear gloves and cover the ink bottle cap with a paper
towel etc. Being in that status, slowly shake it twenty times and more by flowing ink.
2
Remove the cap of the ink bottle.
3
Attach the specialized cap to the ink bottle.
(1) Set the specialized cap on the bottle.
• The specialized cap that is used differs depending on the type of ink that is set.
• Before shaking it, check that the cap is firmly closed.
• If you shake it too strong, it may cause ink leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the bottle cannot be beaten enough. Tilt the
ink bottle until it becomes vertical.
• If using LUS-150, remove the cap
before using a utility knife to open
the seal attached to the bottle. When
opening the seal, cut a circle as
shown in the figure below. Make
sure that the seal does not fall into
the bottle.
Cover with paper towel firmly and shake ink slowly
Repeat this
Use a utility knife to cut a circle as shown
in the figure.
Cap A Cap B
View of upside-down cap
The edge of Cap B is thicker.
Specialized cap
Type of ink Cap used
LUS-150 ink Cap A
LUS-200 ink Cap B
LH100 ink Cap B
Primer ink Cap B
LUS-120 ink Cap B
LUS-350 ink Cap B
To Next Page
Loading...
