1-6
Carriage
The carriage is provided with the heads for printing and LED UV
unit.
Capping station
The capping station consists of the ink caps, the wiper for cleaning
the heads, etc.
The ink caps prevent the nozzles in the heads from drying up.
The wiper cleans the nozzles in the heads.
The wiper is consumable.If the wiper is deformed or the media is
stained, replace the wiper with a new one. ( P.4-27)
EMERGENCY SWITCH
One EMERGENCY switch is placed on the front face
of the unit, two are on Y-bar, and one on the back.
When stopping the machine for safety reason, press
the switch.
• Do not expose your naked eyes directly to the light
irradiated from the LED UV when it lights.
• Do not touch the LED UV unit when it is being lit or
just after it is set OFF. It may cause a burn injury, as it
is very hot.
• Be sure to wear the attached goggles in cleaning within the capping station to protect your eyes
against ink. Otherwise, you may get ink in your eyes.
When you press the emergency switch
and the machine stops, be sure to follow
the procedures below:
(1) Disconnect from the outlet before
resolving the fault.
(2) After checking the safety, pull the
emergency switch upward (or rotate)
to release.
(3) Connect to the outlet.
To Next Page
Loading...
