3-18
Changing printing origin
Changing printing origin with JOG keys
1
Press in LOCAL.
• The origin mode starts.
When is pressed, proceed to step 4.
When is pressed, proceed to step 2.
2
Press to select the area to set the origin.
3
Press the key.
4
Move the light pointer mark by pressing
.
• A red light pointer mark [●] is projected on the table or the media.
• Move the light pointer mark to the position to set a new origin.
5
Press the key when the printing origin is
determined.
• The origin is updated.
• For the setting procedure when the toggle print function is set to OFF, refer to P.3-2 "Changing origin".
• When [[F]/[R] SETUP] is set to "COMMON", the set value is registered to both FRONT/
REAR areas.
• When [[F]/[R] SETUP] is set to "INDIVIDUAL", the set value is registered only to the
selected area.
• The set value for the origin set with the JOG keys is cleared by cutting the power.
<FRONT> OR IGIN SETUP
500 . 0 - - - -
<REAR> OR I G I N SETUP
500 . 0
<REAR> OR I G I N SETUP
500 . 0 600 . 0
Origin
position
(back and
forth)
Origin
position
(right and
left)
To Next Page
Loading...
