MIMAKI JFX200-2531 - Setting Automatic Area Toggling for Toggle Printing

3-10
Setting automatic area toggling for toggle printing
Set whether to toggle the printing area automatically after online drawing.
For details about setting Work Change while the toggle print function is set to OFF, refer to P.3-33 "Setting
Work Change".
1
Press the key in LOCAL.
2
Press to select [SETUP].
3
Press the key.
4
Press to select [WORK CHANGE].
5
Press the key.
6
Press to select a set value.
OFF: Does not toggle the printing area after online drawing. (When the next printing data has been
received, it will be overprinted.)
ON: After online drawing, the Y-bar is retracted, and the printing area is toggled. After printing the
FRONT-side area, the printing area is toggled to the REAR-side area. After printing the REAR-
side area, the printing area is toggled to the FRONT-side area.
HOST: The printing area is toggled according to the set value specified in RIP software.
For the specifying method with the RIP software, refer to the operation manual of the RIP software.
7
Press the key.
• When set to "OFF", proceed to step 12.
• When set to "ON"/"HOST", proceed to step 8.
• The Y-bar is retracted to the machine center.
FUNCT I ON
VIEW [ENT]
FUNCT I ON
SETUP [ ENT ]
SETUP
DROP . POS c o r r e c t [ ENT ]
SETUP
WO R K C H A N G E [ E N T ]
WO R K C H A N G E
:OFF [ENT]
WO R K C H A N G E
:ON [ENT]
SET UP
WO R K C H A N G E [ E N T ]
WO R K C H A N G E
VACUUM: OFF