MIMAKI JFX200-2531 - Page 65

Toggle Printing
3-11
1
1
3
Convinient use
5
6
8
Press to select a set value.
• OFF: Turns OFF the vacuum for the area where printing has completed after automatic toggling of print
area.
• ON: Vacuum for the area where printing has completed stays ON after automatic toggling of print area.
9
Press the key.
10
Press to select a set value.
REMOTE: Stays in remote status after automatic toggling of print area.
(When the next printing data has been received, printing starts.)
LOCAL: Transfers to the local mode after automatic toggling of print area.
To start next printing, press the [REMOTE] key to transfer to the remote mode.
AUTO:
• Stays in remote status if vacuum for the next printing area is ON after automatic toggling of print area.
(When the next printing data has been received, printing starts.)
• Determines that the media is not set and transfers to the local mode, if vacuum for the next printing area
is OFF after automatic toggling of print area.
To start next printing, press the [REMOTE] key to transfer to the remote mode.
11
Press the key.
12
Press the key several times to end the setting.
WO R K C H A N G E
VACUUM: OFF
WO R K C H A N G E ( F < - > R )
MOD E : A U T O
WO R K C H A N G E ( F < - > R )
MOD E : R E MO T E
SETUP
WO R K C H A N G E [ E N T ]