MIMAKI JFX200-2531 - Replacing the Waste Ink Tank before the Waste Ink Tank Confirmation Message Is Displayed

Replacing consumables
4-31
1
1
1
4
Routine Maintenance
Replacing the waste ink tank before the waste ink tank confirmation message is displayed
if you replace the waste ink tank before the waste ink tank confirmation message is displayed (before the 2L
tank is 80% (1.6L) full), set the waste ink information to 0% in the Information menu.
1
Perform steps 3 through 6 in “Disposing of waste ink” ( P.4-29) to empty the
waste ink tank.
2
Press the key in LOCAL.
3
Press to select [INFORMATION].
• For the firmware version 1.90 or later, you can also run from
the maintenance menu. For the performance from the
maintenance, please refer to P4-32.
4
Press the key.
5
Press to select [USAGE].
6
Press the key several times until the waste
ink tank information is displayed.
7
Press the key.
8
Press to set the level “0%”.
9
Press the key.
FUNCT I ON
SETUP [ ENT ]
FUNCT I ON
INFORMATION [ENT]
INFORMATION
USAGE [ ENT ]
WA S T E I N K T A N K
=60%
Con f i rm a wa s t e t ank
Leve l : 60%( 1 . 2L )
Con f i rm a wa s t e t ank
Leve l : 0%( 0 . 0L )