MIMAKI JFX200-2531 - Setting Ionizer

3-35
1
1
3
Convenient use
5
6
Setting Ionizer
Set the operation when the ionizer is installed.
1
Press the key in LOCAL.
2
Press to select [SET UP].
3
Press the key.
4
Press to select [IONIZER].
5
Press the key.
6
Press to select a set value.
ON : For normal printing, turn on ionizer before and during
printing to remove electricity. For reverse printing, remove
electricity before printing. Turn on ionizer while shifting to
[View].
OFF : Does not remove electricity.
7
Press the key.
8
Press the key several times to end the setting.
• If you have installed the ionizer but these settings fail to appear, contact the distributor or a MIMAKI
sales office or call center.
FUNCT I ON
VIEW [ENT]
FUNCT I ON
SETUP [ ENT ]
SETUP
DROP . POS c o r r e c t [ ENT ]
SETUP
IONIZER [ENT]
IONIZER
:ON
IONIZER
:OFF
SETUP
IONIZER [ENT]